KATS 8077 is a concentrated form of water based remover
for KATS temporary coatings, which are typically used to
protect vehicles, machines, etc. during transport.
Guidelines for use of KATS 8077:
The coating that is to be removed should remain wet during
the removal process; therefore, do not work in direct
sunlight during hot weather. The ideal temperature should
be 60° - 80°F (16° - 27°C).
Apply KATS 8077 in a good ventilated area without
excessive wind. Before using, review SDS and wear
proper gear.
Apply KATS 8077 to the coated surface, diluted with 6
parts water by volume. Use a handheld compression
sprayer or a KATS Decoater™ Applicator, available from
KATS. Work from top to bottom.
The coating will become white or gray looking as it absorbs
the remover and will slump from the surfaces. DO NOT
ALLOW THE COATING TO DRY DURING THE REMOVAL
PROCESS. In hot, dry, windy weather or where the coated
item is large, it may be necessary to have several people
working at the same time, or remove coating in sections.
Once the coating is removed, rinse off any residue of KATS
8077 thoroughly with clean water. This is particularly
important around headlights and taillights to prevent any
potential stress crack due to the residue.
